CALL: 0418 882 678
Receive a 10% discount on all work booked within the next 14 days.

Brisbane Floor Sanding Page 4

Parquetry Timber Floor Repair with Floor Sanding & Polishing

Often when a house renovation takes place, areas of missing flooring and unpolished timber are exposed. Recently Budget Floor Sanding has been working on such a project in the Brisbane suburb of Balmoral. This particular timber floor has parquetry and after the moving of the kitchen from one part of the living area to another, patches were exposed where there was no parquetry.

Staining and Floor Board Replacement in Brisbanes West End.

Timber floor repairs have been part of restoring wooden floors in a large old Queenslander at West End this week. The timber floors in this house were previously covered in very old carpet and lino. Once the floor coverings were removed it became apparent that much of the old Hoop Pine flooring had an old Black Japan coating and that there was evidence of borer damage in some of the floor. This meant that floorboard replacement was going to be required.

Floor Sanding and Polishing at Ashgrove

floor sanding BrisbaneDuring the past week, Budget Floor Sanding has been working sanding and polishing the floors at a house in the Brisbane suburb of Ashgrove. This house has undergone a major renovation with large areas of new Hoop pine flooring laid as part of an extension.

Effects of Grit and Direct Sunlight After Sanding and Polishing

Sand and grit are harmful to polished timber floors. They are easily bought into homes with footwear. These particles act like sandpaper and can result in scratches on the floor.

Floor Sanding and Polishing in Clayfield

Working around Brisbane this has been a busy first week back to work. Some of the work we have done this week includes;

Floor Sanding & Polishing With Three Different Finishes

 

Floor Sanding and Polishing of Blackbutt Timber Floors

Blackbutt timber flooring has in recent years been a very popular choice of timber flooring in new houses and in flooring extensions. It is a good choice for old Queenslanders undergoing extensions due to its similar color as compared to old Hoop Pine flooring, yet it is much harder than Hoop Pine flooring. Blackbutt is a commonly grown hardwood that has attractive coloring from cream to pale brown, sometimes with a slight tinge of pink. The Janka hardness rating is 9.1. This test is a measure of the force required to press a steel ball into the wood surface to half its diameter. The larger the number the harder the wood.

Floor Sanding and Polishing Timber Floors

Timber floorboards are one of those original features that homeowners long for and real estate agents crow about. They are synonymous with contemporary interiors. They are not new of course, with timbers such as Queensland Hoop Pine used in some of our oldest Brisbane homes. With mass production of tongue and groove flooring, timber flooring was by far the most popular domestic choice in homes.

Timber Floor Installation at Fig Tree Pocket

Last week Budget Floor Sanding did a floor installation job for one of our regular builders. This installation involved laying Spotted Gum Flooring over concrete and over the yellow tongue. The timber is best put onto the site two weeks in advance so that it may acclimatize to the site conditions, and then prior to installation the moisture content of the timber is checked to make sure it falls within the acceptable range.  Before the flooring can be installed over concrete firstly a plastic membrane is laid over the concrete to combat any moisture which may find its way through the concrete slab. Then timber battens are attached to the concrete by way of masonry anchors.

Floor Sanding in Woolloongabba

Recently Budget Floor Sanding completed a large floor sanding and polishing project in a house in the Brisbane suburb of Woolloongabba. The floors in this old Queenslander had an old black japan finish on them and also showed evidence of borer damage. Photos showing the transformation of the floors can be seen under the board replacement header on this web site. After the first sand of the wooden floor, the damaged floorboards were then identified and replaced. This amount to be replaced was done in conjunction with the owner who decided that some boards with only lighter damage would remain. At the completion of the floor sanding, the floor was then finished with a water-based two-pack finish, and also during this process, the new replacement floorboards were stained to blend them into the color of the original timber floorboards. Quite a transformation.

↑ Top of Page